≡ Application Guides
Home Products Powertrax 92-0435-2705 No-Slip Locker; Dana 35

Powertrax 92-0435-2705 No-Slip Locker; Dana 35

Combines the smooth operation of a limited-slip differential, with the traction performance of a locking differential
A precise synchronization mechanism eliminates the ratcheting sounds typical of other locking differentials
Special gear and spring design reduce the backlash and therefore driveline windup

SKU: ptx-92-0435-2705 Category:


Powertrax 92-0435-2705 No-Slip Traction Systems for the Dana 35 axle (with any gear ratio and 27-spline C-clip shafts) are the latest design in traction-adding differential technology. They combine the smooth, near-silent operation of a limited-slip differential with the traction-adding performance of a full locking differential. A precise synchronization mechanism eliminates the ratcheting sounds typically heard in other locking differentials. The Powertrax No-Slip Traction System features a precision engineered gear and spring design that reduces the backlash, and, therefore, the driveline windup. Only ultra-strength material that is 67% stronger than titanium is used. Installation is simple because no ring and pinion setup is required and the No-Slip fits into the factory open differential carrier — no need to buy additional parts. In addition, no special tools or oils are needed. Step-by-step, model-specific instructions are provided with every kit.

Powertrax 92-0435-2705 No-Slip Traction System is for use on Dana 35 axles with any gear ratio, 27-spline C-clip shafts, 1.625″ side gear bore, and an open carrier.
Will not fit axles with a limited slip differential carrier.

This axle is commonly found on (but not limited to) the following vehicles. Please note that this is not a definitive list. Your vehicle may differ.

  • 1980-88 AMC Eagle, rear
  • 1991-94 Ford Explorer, front
  • 1987-97 Ford Ranger, front IFS
  • 1986-92 Jeep Comanche MJ, rear
  • 1987-93 Jeep Wrangler YJ, rear

Advantages of a Powertrax No-Slip

  • Automatic Operation: No need to engage or disengage the Lock-Right unit and it automatically operates in forward or reverse.
  • Strong and Durable: Made of material that’s 67% stronger than titanuim.
  • Easy Installation: Requires minimal tools and time for installation. You can install it at home.
  • No Special Fluids: No special lubricants or adjustments required to operate the unit.
HINT: This traction system is for use with a differential carrier that was predominantly installed in vehicles up to 1993 without ABS. If your non-ABS Dana 35 is on a 1993+ vehicle, then chances are it will need the Powertrax No-Slip Traction System; Dana 35 (ABS), even if it doesn’t have ABS.